• 189-17 Jamaica Avenue Hollis NY 11423
  • 105-24 Cross Bay Blvd, Jamaica, NY 11417
  • TEL:718-217-4444
THIS SCHOOL IS LICENSED BY THE STATE OF NEW YORK.

Tanker Test 1

1.
S-cam brakes.
Drum brakes.
Foot brakes.
Emergency brakes.

1.
After every working day.
After every four hours of service.
Once a week.
Every other week.

1.
To keep from fouling the air compressor oil.
Water can freeze in cold weather and cause brake failure.
The low boiling point of water reduces braking power.
Water over cools the compressor.

1.
A supply pressure gauge.
An air use gauge.
At least two brake heaters.
A backup hydraulic system.

1.
Fluid pressure
Air pressure
Spring pressure
Any of the above

1.
1 psi in 30 seconds
1 psi in one minute
2 psi in 45 seconds
3 psi in one minute

1.
Pump the brake pedal rapidly and lightly.
Brake hard until the wheels lock, and then get off the brakes for as much time as the wheels were locked.
Brake as hard as you can, get off the brakes when the wheels lock, get back on the brakes when the wheels start rolling again.
Press hard on the brake pedal and apply full hand valve until you stop.

1.
Pressure on the brake pedal is released and speed increases.
You have to push harder on the brake pedal to control your speed on a downgrade.
The brake feels spongy when pressure is applied.
Less pressure is needed on the brake pedal for each stop.

1.
Park on level ground, chock the wheels, and release the parking brakes.
Stop on level ground and apply the parking brakes.
Park on level ground and drain off air pressure before adjusting.
Park on a slight grade, release the parking brake, apply the service brakes, and check for vehicle movement.

1.
The tractor protection valve
The emergency relay valve
The one way check valve
The air compressor

1.
Use stab braking.
Begin braking when you are 10 M.P.H. above your safe speed.
Release the brake when you are 5 M.P.H. below your
Use the trailer brakes.

1.
Service brake system.
Emergency brake system.
Parking brake system.
None of the above.

1.
Disc brakes
Wedge drum
S-cam drum
None of the above

1.
At least two air tanks.
An air pressure gauge to show the pressure available for braking.
An air pressure gauge, to show air used by the brake chambers for braking.
None of the above.

1.
80 psi
40 psi
20 psi
60 psi

1.
Brake lag distance.
Action distance.
Perception distance.
Effective braking distance.

1.
Open the air supply control valve.
Adjust the brake pedal for more travel.
Stop and safely park as soon as possible.
Up-shift.

1.
Can only be tested by highly trained brake service people.
Depends on the adjustment of the service brakes.
Increases when the service brakes are hot.
Is not affected by the condition of the service brakes.

1.
When air is pumped into the air tanks.
Air pressure applied to the brakes.
The speed of the air compressor.
When the brake chambers release pressure.

1.
Has been used on the trip.
Is in the air tanks.
None of these.
Is being applied to the brakes.

1.
Clean the air filter with alcohol.
Check and fill the alcohol level.
Change the alcohol from a new bottle.
Check the oil for alcohol content.

1.
Spring pressure
Bolts or clamps
Centrifugal force
Air pressure

1.
Need to have airflow through the lines to work.
Use different brake drums.
Require heavier return springs.
All of the above.

1.
To hold your speed when going downhill.
Whenever the vehicle is parked.
As little as possible.
Only during pre and post trip inspections.

1.
Is to be used as a footrest during normal driving.
Controls the speed of the air compressor.
Controls the air pressure applied to put on the brakes.
Is connected to slack adjusters by a series of rods and linkages.

1.
Balance the service brake system.
Release the spring brakes to move a short distance.
Stay parked without using up service air pressure.
Apply more brake pressure if the main tank is getting low.

1.
4
3
2
1

1.
Reduce the risk of ice in air brake valves in cold weather.
Eliminate the need for daily tank draining.
Rid the wet tank of alcohol that condenses and sits at the bottom.
Boost tank pressure the same way that superchargers boost.

1.
Use the full power of the brakes and lock them.
Can steer hard while braking hard.
Stay in a straight line and can steer.
Use the hand brake first.

1.
Reduce your speed and drive to the nearest garage for repairs.
Continue at normal speed and find a garage before the brakes lock.
Reduce your speed and test the remaining system while under way.
Stop. Safely park, and continue only after the system is fixed.